| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
Hi all, I have encountered an error when bringing up my youbot. It says " Not enough ethercat slaves to create a youbot manipulator" and hence, my arm is not working. Urgently help is needed thank you!
We really need to know which driver are you using, a good driver for the youbot can be found here.
Then execute ifconfig on the physicall robot terminal to get the ethernet adapter names. The Ethernet adapter name needs to be configured in ethercat.cfg
When the names don't match you get the error you are describing.
Hope it helps... unfortunately we can't give any more specific directions if you don't inform us about which youbot driver are you using... for the record, the one from youbot store can be found here
Asked: 2017-10-10 03:08:58 -0500
Seen: 229 times
Last updated: Oct 17 '18
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
Hi herroineedhelp, Can you send screenshots ? Which Ethercat software driver you are using and which ethercat motion controller you are using for manipulator?