| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
Yes, you do. The Create needs to be put in "full" mode to enable the breakers. This can be done by using the Mode button on the TurtleBot dashboard, or by sending it motion commands (using one of the teleoperation examples or your own code).
If it's still not working when it's in full mode, use the dashboard to check that breaker 0 is set. Breaker 0 should automatically be set, though.
I am having problem while connecting the kinect power using DB25 connector of Irobot create base. The connector circuit is designed by clearpath robotics to provide 12V DC power to kinect by taking power from pin 10 and 14 of DB25 connector of irobot create base.
Asked: 2011-10-10 08:48:13 -0600
Seen: 797 times
Last updated: Oct 10 '11
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
I am having problem while connecting the kinect power using DB25 connector of Irobot create base. The connector circuit is designed by clearpath robotics to provide 12V DC power to kinect by taking power from pin 10 and 14 of DB25 connector of irobot create base.