| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
/cmd_vel is a subscriber itself so you have to publish to it.
provided that you setup everything right, (rosserial), and when you do a rostopic list, you see /cmd_vel in the list of topics, you type
rostopic pub /cmd_vel geometry_msgs/Twist and hit tab, twice it will show:
rostopic pub /cmd_vel geometry_msgs/Twist "linear:
x: 0.0
y: 0.0
z: 0.0
angular:
x: 0.0
y: 0.0
z: 0.0"
Modify the linear speed, twist.linear.x to be 0.5 for example, and twist.angular.z for the angular speed, for example 0.4 and it will make the robot move in a circle, with speed of 0.5m/s.
Hope this helps, -C.A.
Yes, the above scheme publishes to arduino. /cmd_vel is a subscriber running on the arduino. you publish to it, from anywhere.
For example look at this tutorial: http://wiki.ros.org/rosserial_arduino..., this code runs on the arduino, subscribes to /toggle_led - when someone publishes to /toggle_led, either from command line, or from a python script, the /toggle_led subscriber takes that messages, and turns on/off the led.
Instead of /toogle_led make a subsriber /cmd_vel with Twist message type. There should be code available if you search for it.
This could be useful: https://answers.ros.org/question/2970...
Best regards, C.A.
Yes you can use an arduino to subscribe to cmd_vel topic, or any topic for that matter. Just include the necessary header file. In your case, that would be:
#include <geometry_msgs/Twist.h>
and then initialise the subscriber as below:
ros::Subscriber<geometry_msgs/Twist> sub("cmd_vel", &callback_func)
See this, http://wiki.ros.org/rosserial_arduino...
use e.g
nh.loginfo("Hello world");
I believe this should appear as outputs in your rosserial node.
Asked: 2019-11-07 08:32:15 -0600
Seen: 1,624 times
Last updated: Nov 09 '19
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
