| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
Hi,
I was wondering what coordinate space RViz markers work in (Pose or Points parameters).
I have an object with Pose of 5000, 5000, 0, however when I open RViz and draw a Marker with 0, 0, 0 coordinate, it draws it directly over the object.
What's wrong?
RVIZ markers specify their frame_id in the message, along with their pose. So if you specify a point at (0, 0, 0) then it will be shown at the origin of the given pose defined within the coordinate system of '<frame_id>'
I usually set the pose to identity to keep things simple, and calculate the marker points directly within the specified frame, but that isn't always appropriate.
Regarding the problem you describe can you post a screen-shot along with the code which produces it. We'll just be guessing without it.
Asked: 2019-06-10 09:59:03 -0600
Seen: 421 times
Last updated: Jun 10 '19
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
