| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
The process has been blocked，so you cannot use Ctrl c to kill the node. However, it is not recommended to allow the program to work in a blocked state.You can use function selectwhen you use readto get some data in UDP or serial port process.
Despite the possible way to kill an app by invoking the Ctrl +C in the termina, that is not the proper way to finish/dispose a living node, you should do instead:
$rosnode kill yourNodeName
the reason is that Ctrl +C may not give the chance to the node to dispose itself properly, before the node dies it must isself disconnect from Master, release resources, etc etc which may not happen by doing just Ctrl +C
btw
$rosnode cleanup
will guide you diagnose, and purge those zombie nodes
As far as I know, roscpp installs a signal handler for Ctrl-C, which will do a clean exit. I'd guess rospy and other client libraries do the same.
Having just a
while(1)
{
printf("something \n");
}
in main blocks the node, cannot kill it with anything else than System Monitor or linux command line. Any ROS providen method does not work.
It only hides it from the ROS environment, but the process is still there.
yes, you'd need to do while(ros::ok()){ ... }. My understanding is, that the ros signal handler will make ros::ok() fail, instead of killing the program. This way you can stop whereever convenient. Btw: Ctrl+Backslash will kill your program in the shell, but without any chance for cleanup.
Asked: 2017-03-28 02:19:35 -0600
Seen: 12,610 times
Last updated: Mar 28 '17
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
please post the code, it's hard to help debugging without any..
thank you，it has been sloved
hi! I meet the same problem with you , can i have chance to know how you solved this problem? thank you a lot !
施佳伟？ 程序阻塞了，用select函数可以解决。
@Tomas yuan: could you please only use English on ROS Answers? Thanks.
您好！ 没想到你也是中国人啊 呵呵。 我叫贾士伟。 根据你的指点，没找到select函数啊，你是在哪找的呢？ 我用的是boost 里的udp
Hi,nice to meet you .Boost library may not contain the
selectfunction,you can useasync_read()to work in asynchronous way for data reading .Here is boost::ASIO的异步方式 .And if you donnot use the boost class , you can directly use socket for udp