failed to connect xbee.
when i run the following command i got "Failed to connect to the XBee"
command..."rosrun rosserial_xbee setup_xbee.py /dev/ttyUSB0 0"
i am using ros-hydro.
ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
when i run the following command i got "Failed to connect to the XBee"
command..."rosrun rosserial_xbee setup_xbee.py /dev/ttyUSB0 0"
i am using ros-hydro.
Can you connect to the xbee using X-CTU? Also, since the coordinator needs an ID of 0, you should use rosrun rosserial_xbee setup_xbee.py -C /dev/ttyUSB0 0
ya i can connect it using X-CTU........and also i have used ''rosrun rosserial_xbee setup_xbee.py -C /dev/ttyUSB0 0"......but same error....please any other way to solve it.....
ye sir....i am using series 1 xbees.......also i have checked with xbee pro....but same result....
i am also getting the same error though connected xbee on ttyUSB0 and also i can connect it to XCTU
It gets solved by setting the baud rate of 57600 in X-CTU.
Asked: 2014-03-31 23:52:05 -0500
Seen: 875 times
Last updated: May 25 '16
No transform from [] to [robot_1/odom] [closed]
Why does this rosserial arduino code only permits a single subscriber?
Translating Cartesian Coordinates from Hand frame to World Frame: ROS & Baxter Help
Why collision is not working for UR5
Ros ultrasonic sensor Rviz Error
Why ar_track_alvar is not installing?
How to make tf file for pcd/vector map
"camera_odom_frame" passed to lookupTransform argument target_frame does not exist
A little more context information will go a long way in helping you.