Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

Ok so found the problem. Whilst the ROS_IP addresses were set correctly I'm running the heavy weight ROS side on a virtual box and the sensor/actuator side on rasp pi. It was the network setup of the VM it was set to NAT - changed it to bridged. Now all is well.

Thanks

Mark

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.