ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange

Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

0

turtlebot kinect power

asked 2012-04-21 18:19:38 -0500

shriphani
1 ●1 ●1 ●1

Hello everyone. I was trying to test out the board on my turtlebot (I don't have ROS setup yet but I should have access to my computers soon). I am only using serial commands over realterm. I used a crimping tool, cut out the power-adapter from the Y-splitter and connected the red/brown wires as shown in the manual and plugged them in (as pic1 pic2)

I then set the create to Full mode via realterm but the kinect isn't powered on at all (blinking green light). Can anyone help me power the kinect using just OI (I don't have a laptop to run ROS on atm and I would really like to see if I have any defective hardware.

Thanks, Shriphani P

edit retag flag offensive close merge delete

Comments

I am having problem while connecting the kinect power using DB25 connector of Irobot create base. The connector circuit is designed by clearpath robotics to provide 12V DC power to kinect by taking power from pin 10 and 14 of DB25 connector of irobot create base.

lifelonglearner ( 2013-07-25 23:50:46 -0500 )edit

1 Answer

Sort by » oldest newest most voted

0

answered 2012-04-21 21:02:10 -0500

flag of United States of America

47576 ●179 ●367 ●662 http://namniart.com/

The Kinect requires both USB and 12V power to operate.

You should get a multimeter and measure the voltage on the power connector to confirm that it is producing 12V.

edit flag offensive delete link

Comments

I am having problem while connecting the kinect power using DB25 connector of Irobot create base. The connector circuit is designed by clearpath robotics to provide 12V DC power to kinect by taking power from pin 10 and 14 of DB25 connector of irobot create base.

lifelonglearner ( 2013-07-25 23:50:40 -0500 )edit

please ask a new question.

ahendrix ( 2013-07-26 10:44:30 -0500 )edit

I have asked the question with more detailed information.... need you help. pls visit question here ........
http://answers.ros.org/question/67618/kinect-power-problem-while-connecting-to-the-irobot-create-base/

lifelonglearner ( 2013-07-26 16:42:34 -0500 )edit

Question Tools

1 follower

Stats

Asked: 2012-04-21 18:19:38 -0500

Seen: 935 times

Last updated: Apr 21 '12

Related questions

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.10.2