| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
/rtabmap/odom runs at about 16Hz. However, when visualizing it in RViz, the vector seems to move at a much slower rate: 1-2 Hz, in spite of rviz reporting that it receives messages from rtabmap at the rate I expect. How can I make rviz visualize the rtabmap data at the same rate as the white line in the rtabmap viewer?
Did you compare with TF shown in RVIZ? For the Odometry display in RVIZ, there are "Position Tolerance" and "Angle Tolerance" parameters that can be set to 0 if you want to show all odometry messages.
Asked: 2016-12-14 23:53:42 -0500
Seen: 282 times
Last updated: Dec 19 '16
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
