Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

I tried it with Bumblebee and make sure that optimus is working, but even with that I did not see any GUI appearing.

So, finally, I just pulled the the original PTAM source code. With that build, I could run the calibration tool (with GUI) and even without using optimus.

As I don't have enough Karma.. you can find some useful Links below in the comments

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.