ROS natively on the iRobot Create Command Module
Hi,
Does anyone know if it's possible to run ROS natively (i.e. cross compiled) on the Command Module for iRobot Create?
thanks,
Nick
ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
Hi,
Does anyone know if it's possible to run ROS natively (i.e. cross compiled) on the Command Module for iRobot Create?
thanks,
Nick
There is not a native release of ROS for 8-bit platforms, so a native executable for the command module is not available.
It is highly unlikely that ROS will ever target a platform that constrained, since most of the focus is on higher-level research.
There are several libraries available for communicating with the iRobot from ROS though. You can check out everything available on the Robots for ROS - Roomba Page.
As @mjcarroll said ROS is not designed to run at the level of 8 bit microcontrollers, communications are abstracted at an IP level which most microcontrollers don't have available.
There are several driver stacks for the iRobot Create icreate, turtlebot, and irobot_create to name a few from a search of indexed ROS repositories.
Asked: 2011-03-27 20:26:28 -0500
Seen: 351 times
Last updated: Mar 28 '11
Calibrating turtlebot odometry without gyro/imu
Frozen map + 'Message filter dropping'... Issues with mapping and navigation
Does anyone have a URDF model or Gazebo simulation of the Wild Thumper 6WD?
GumROS log4cxx compilation problem
Catkin cross-compilation of ros-groovy for Zynq ARM target
cross compilation of groovy using catkin: librospack.so not found