PWM control (Rosbot 2.0)
Hi, I'd like to know how to control the PWM signal directly. The motor is controlled by cmd_vel by using ros node but how to control the PWM without cmd_vel msg?
ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
Hi, I'd like to know how to control the PWM signal directly. The motor is controlled by cmd_vel by using ros node but how to control the PWM without cmd_vel msg?
The Rosbot 2.0 uses an ASUS Tinker board for low level control. You have the ability to read PWM from the servos but you can also interact with the firmware via rosservice to set PWM: https://github.com/husarion/rosbot-st...
$ rosservice call /config "command: 'CSER'
>data: 'V:0 S:1 E:1 P:20000 W:1000 '"
Just connect to the hbridge of the core2
Asked: 2021-10-20 01:46:21 -0500
Seen: 305 times
Last updated: Oct 21 '21
Trajectory "succeeds" before goal point
roslaunch: add further condition in launch-prefix
how to make end effector look at object?
unable to build the package using catkin build
fatal error: 'ros/ros.h' file not found
spawn multiple robots in RVIZ using one URDF/XACRO file
How to connect Turtlebot in Gazebo to a Web Interface
Connecting & Reading to a TCP/IP socket from a different ROS Node