Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

Did you bringup the turtlebot before starting rviz? Run this command on the turtlebot after starting roscore on your host PC. You should see the LIDAR start spinning and the turtlebot will be ready to start taking commands.

turtlebot3_bringup turtlebot3_robot.launch

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.