Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

Maybe you could restart the robot. Sometimes I have this problem, but when I restart my turtlebot, it's gone. It's nomal If your turtlebot turn 720° continuously in a routine, where each routine begins with "Aligning base with wall" and ends with IMU and odom error output.

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.