Ask Your Question
1

ROS for x86 Galileo board using Yocto

asked 2013-11-10 03:56:00 -0500

updated 2014-01-28 17:18:30 -0500

ngrennan gravatar image

Hi community,

I'd like to create a Linux for my brand new x86 Intel Galileo board. The installed Linux is based on a Yocto-build, which is source-code available.

Has anyone got experience on how to package ROS with Yocto? I found only a year old thread on this topic, where it has been discussed for ARM devices. State back then was more or less, no further info available (yet)...

Best regards Christoph

edit retag flag offensive close merge delete

1 Answer

Sort by ยป oldest newest most voted
3

answered 2013-11-24 00:19:39 -0500

updated 2016-07-24 14:59:30 -0500

Since beginning of this year there is a project that provides a build-layer for Yocto:

http://wiki.ros.org/hydro/Installatio...

Stumbled over it by pure luck, but initial installation worked ok, so I can recommend it as a good starting Point :-)

Best regards Christoph


Meanwhile I switched to Intel Edison (as Galileo turned out to be quite on the lowest possible edge of what is still doable for ROS). I have good experiences with meta-ros.

Good luck everyone! :-)

edit flag offensive delete link more

Comments

http://wiki.ros.org/IntelGalileo Also has some directions.

tfoote gravatar image tfoote  ( 2014-01-04 14:17:49 -0500 )edit

Your Answer

Please start posting anonymously - your entry will be published after you log in or create a new account.

Add Answer

Question Tools

2 followers

Stats

Asked: 2013-11-10 03:56:00 -0500

Seen: 436 times

Last updated: Jul 24 '16