| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
I am searching for a sophisticated way to calibrate a Schunk (Amtec) arm where some joints are not in zero position (when they should be). Is there a ROS package for this purpose? Would it be possible/recommended to use the pr2_calibration stack? Thanks for advice, David
There has been a similar question with excellent answers here. In summary: Theoretically, you should use the robot_calibration and/or pr2_calibration stacks, and there seems to be a lot of interest in that, but at the moment these stacks are not really portable. That means you will have to do some serious reconfiguration to get it going on your robot.
The PR2 definitely needs its joints re-zeroed during the calibration process, and the pr2_calibration stack does take care of this. However, I will reiterate Martin's response in that the stack is not designed to be portable, and further information is available at http://answers.ros.org/question/102/how-can-i-calibrate-my-real-robot.
Asked: 2011-05-02 10:04:26 -0500
Seen: 1,111 times
Last updated: Jul 14 '11
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
