PWM control (Rosbot 2.0)
Hi, I'd like to know how to control the PWM signal directly. The motor is controlled by cmd_vel by using ros node but how to control the PWM without cmd_vel msg?
ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
Hi, I'd like to know how to control the PWM signal directly. The motor is controlled by cmd_vel by using ros node but how to control the PWM without cmd_vel msg?
The Rosbot 2.0 uses an ASUS Tinker board for low level control. You have the ability to read PWM from the servos but you can also interact with the firmware via rosservice to set PWM: https://github.com/husarion/rosbot-st...
$ rosservice call /config "command: 'CSER'
>data: 'V:0 S:1 E:1 P:20000 W:1000 '"
Just connect to the hbridge of the core2
Asked: 2021-10-20 01:46:21 -0500
Seen: 296 times
Last updated: Oct 21 '21
odom_vel, cmd_vel, trajectory planner
Undefined reference to `GeographicLib::UTMUPS::Forward(...)
MATLAB ROS read torque and position
Is it possible to stop or restart a node at run time?
ComplianceRos error in catkin_make
rqt_reconfigure gui config files
No Module Named catkin.builder
Stage and Rviz : Incompatibility
boost: mutex lock failed in pthread_mutex_lock: Invalid argument