Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

How to enable vehicle_cmd in autoware ?

asked 2020-03-03 02:59:04 -0500

sneibus
21 ●10 ●12 ●14

updated 2022-05-23 09:52:52 -0500

lucasw

8729 ●137 ●239 ●256 https://github.com/lucasw

Hi folks, Installed autoware and visualized the rosbag however i want to see the vehicle cmd but it doesn't show/ doesn't recognize as it shows as unknown. Anyone know how to go about it please desperate here.

Thank you

edit retag flag offensive close merge delete

add a comment

1 Answer

Sort by » oldest newest most voted

answered 2020-03-03 13:14:45 -0500

Patrick N.
65 ●6 ●12 ●14

If you are trying to use rostopic to echo it, then I usually source the autoware setup.bash in the terminal I intend to run the rostopic command.

edit flag offensive delete link

Comments

Hi do you have a set of instructions/ command i could follow plz. I'm new to all of this. thank you

sneibus ( 2020-03-03 15:47:49 -0500 )edit

Are you using the docker or did you compile from source?

Patrick N. ( 2020-03-03 20:45:07 -0500 )edit

add a comment

Question Tools

2 followers

Stats

Asked: 2020-03-03 02:59:04 -0500

Seen: 288 times

Last updated: Mar 03 '20

How to enable vehicle_cmd in autoware ? edit

1 Answer

Comments

Question Tools

Stats

Related questions

How to enable vehicle_cmd in autoware ?