Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Mini-Turty robot get stuck on corner when navigating

asked 2019-02-12 09:18:07 -0500

tfurgerson
11 ●2 ●3 ●4

updated 2019-02-12 10:41:31 -0500

I created a map using a Rhoeby Dynamics Mini-Turty II robot and am using that to do navigation. It works most of the time, but sometimes it gets "stuck" on corners. As far as I can determine, it seems to create a global path that is too close to the obstacle (eg. corner of a wall). Then when it navigates along the path, it appears to just barely enter the "lethal" area and then gives up (goes into recovery behaviors). Is there a way to have the global path take a wider route around obstacles?

The robot is using Ubuntu 16.04 on Raspberry Pi 3, Kinetic, Move Base, DWA planner and AMCL.

edit retag flag offensive close merge delete

Comments

I am having the same problem

vcavinat ( 2019-10-10 04:18:43 -0500 )edit

add a comment

1 Answer

Sort by » oldest newest most voted

answered 2021-10-06 01:39:27 -0500

Siddhantoon
1

To make the robot move far from obstacles decrease the cost-scaling factor it will make the curve less steep in terms of cost. Robot will try not to go too near the obstacles.

edit flag offensive delete link

add a comment

Question Tools

1 follower

Stats

Asked: 2019-02-12 09:18:07 -0500

Seen: 724 times

Last updated: Feb 12 '19

Mini-Turty robot get stuck on corner when navigating edit

Comments

1 Answer

Question Tools

Stats

Related questions

Mini-Turty robot get stuck on corner when navigating