XV-11 Lidar Connected but not appearing on rviz
Hi,
I have installed ubuntu 16.04 and ros kinetic on my odroid xu4 to use xv11 lidar. I have connected lidar with an arduino mega to the odroid. I just followed the steps on ros wiki for installing xv11 driver, ros kinetic and it all worked until I get rviz command for my project. After I type:
roscore&
rosrun xv_11_laser_driver neato_laser_publisher _port:=/dev/ttyACM0 _firmware_version:=2
commands at ssh from my PC; It doesn't then I open a new terminal at my odroid and type rviz to see if it works. However it gives me an error that says:
Unable to find an xv11 visual which matches EGL config 9
Could not initialize OpenGL for RasterGLSurface, reverting to RasterSurface.
libGL error: unable to load driver: exynos_dri.so
libGL error: driver pointer missing
libGL error: failed to load driver: exynos
Unable to find an xv11 visual which matches EGL config 9
Could not initialize OpenGL for RasterGLSurface, reverting to RasterSurface.
Is it because of the qt bug that I have read while searching for unable to find an xv11 visual which matches EGL config 9 error, or is it because of something else? I am a newbie on both odroid, ubuntu and ros so could you please explain the problem simple for me? I will try to do the same steps tomorrow morning on a raspberry pi 3 b and edit here if it works.
Note: I am following this tutorial; http://roboticsweekends.blogspot.com/... for the all process. Except I am using odroid xu4 instead of a raspberry pi.
