Hi,

I am learning Baxter Robot using ROS in C++ language. For getting used to with ROS and Baxter, I am writing a C++ program to control Joint position. Before writing the code, I looked in the list of rostopics, by executing rostopic list command. Later on, I found out that /robot/limb/right/joint_command topic is used for controlling the joints. I looked in this ros message for more info. Below is the command run at terminal-

[baxter - http://localhost:11311] ravi@dell:~/ros_ws$ rostopic info /robot/limb/right/joint_command
Type: sensor_msgs/JointState

Publishers: None

Subscribers: 
 * /gazebo (http://localhost:45341/)

Based on the above output, I write following code-

ros::init(argc, argv, "move_joints");
ros::NodeHandle node;
ros::Publisher joint_pub = node.advertise<sensor_msgs::JointState>("/robot/limb/right/joint_command",10);
sensor_msgs::JointState joint_state;
joint_state.name.push_back("right_e0");
joint_state.name.push_back("right_e1");
//The remaining lines are not being shown here, to shorten the code
joint_state.position.push_back(0.0);
joint_state.position.push_back(0.0);
//The remaining lines are not being shown here, to shorten the code

I complied the code using catkin_make and it compiled successfully without any error. But while running the code, it throws the error. Please see the below output from terminal-

[baxter - http://localhost:11311] ravi@dell:~/ros_ws$ rosrun tools move_joints
[ERROR] [1448935306.651614576]: Client [/gazebo] wants topic /robot/limb/right/joint_command to have datatype/md5sum [baxter_core_msgs/JointCommand/19bfec8434dd568ab3c633d187c36f2e], but our version has [sensor_msgs/JointState/3066dcd76a6cfaef579bd0f34173e9fd]. Dropping connection.

This gives me a hint that the message type mismatch is occurred. Somebody help me to overcome with this issue.