| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
I have installed ROS on Jetson TK1. When I connected sensors (like Kinect, RPlidar ) to the USB port and list the device, the device did not appear as expected ($ ls /dev/ttyUSB* ). How to deal with this?
Cheers, Rickardo
Hi Rickardo,
I had the same issue, and what the problem was is the SERIAL and FTDI kernel modules were not built for the jetson TX 1for some reason. the Jetson TX1 uses the arm64 arch and you would have to build these drivers from source and install them. check out the Jetson forums: https://devtalk.nvidia.com/default/board/164/jetson-tx1/
Asked: 2015-11-18 07:31:26 -0500
Seen: 1,462 times
Last updated: Nov 18 '15
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
How are they listed? Also can you post output of
lsusb?