Segway Driver
I was able to install the Segwayrmp driver and get it to work properly. But now it is showing a 'checksum mismatch' error. Any solution to this problem?
ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
I was able to install the Segwayrmp driver and get it to work properly. But now it is showing a 'checksum mismatch' error. Any solution to this problem?
If I remember correctly this occurs when there is invalid data sent from the segway device and typically this means some sort of problem with the usb device. I remember debugging this once and finding lots of messages about usb failures in dmesg
. If you are using USB to connect to the segway, try passing it through a powered USB hub or rethinking your power system to try and identify places where your could have different grounds.
Asked: 2014-06-02 09:29:36 -0500
Seen: 167 times
Last updated: Jun 02 '14