| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
Hello,
is there any available package for calibrating the extrinsic parameters of camera + laser range finder system?
I found the old laser_camera_calibration package, but I can't figure out where to find the source (roslocate does not return any result, and it is not in the browse list), and it does not seem to have been worked on since 2009.
Thanks in advance
Raph
You can have a look at the paper of Vijay Pradeep on the calibration of the PR2. (here). And in the source code of PR2. Wim told me that there is an intern working on the extension on the camera pose calibration package, I proposed helping in extending this package to a more general 'multi sensor calibration' package.
Just for future reference. The best package if you have matlab:
http://www-personal.acfr.usyd.edu.au/akas9185/AutoCalib/index.html
By A. Kassir.
How did you store the timestamps for the camera for the RADLOCC toolbox? I could collect the laser and camera data as a rosbag and convert the laser scan into ASCII format. I did not understand the list where I should provide timestamps of the images. Any help on that? Thanks!
Asked: 2011-06-16 00:35:03 -0500
Seen: 2,139 times
Last updated: Dec 02 '14
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
