ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange

Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

You should write some nodes for control that can interface between ROS and your motor controller. I don't know if your robot uses differential drive but if so you can look for instance at the differential drive package. Your own motor node should then accept the motor_cmd commands this node generates. Next step would be to generate a urdf model of your robot so you can use transforms.

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.10.2