Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

had the same issue, first, make sure all steps for configuration and setting the laser scanner is done, according to robotis emaual, then If lidar didn't work and did not start spinning, despite doing all steps mentioned above, check the USB configuration on the robot. Plug and unplug the USB, adding to that, sometimes the cause for this problem is using a USB hub, so unplug the USB hub.

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.