ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange

Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

I was able to find the solution by contacting SICK support. Apparently the IP address of the port you connect to and the IP address of the LIDAR need to be similar (eg if LIDAR is 10.10.10.10 then port IP needs to be 10.10.10.XXX). The opposite is also true, however I was unable to change the LIDAR's IP so I changed the ports'. I followed this tutorial and set up a temporary IP on my port. This solved my issue and can now run sick_scan successfully.

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.10.2