Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

On the Pi3, the serial port is standard configured to the bluetooth adapter. To change this, you have to change the boot/config.txt file : "enable UART=1". After that, I could use the serial port with a python sketch. Tx/Rx is on Pin 14/15 from the Pi3 ! image description Success

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.