ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange
Ask Your Question

Revision history [back]

click to hide/show revision 1
initial version

Hi! I also encountered the same problem and fixed it finally. It displays "Connecting to /dev/ttyACM0 at 57600 baud" while the baud rate in my Arduino code was set to be 115200. Hence, set the baud rate as it was in your arduino code (In my case it is 115200) by adding_baud:=X (where 'X' is the baud rate between your computer and the Arduino) to the same command as follows:

rosrun rosserial_python serial_node.py _port:=/dev/ttyACM0 _baud:=115200

The other reason could be that your port is different from that of the above command. For example, check if your port to which the Arduino is connected, is as entered in the above command i.e, ttyACM0 or ttyACM1 etc .

Hope this helps!