Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

The Navigator says it has finished the exploration, that is why it is not sending any commands. (The robot is supposed to stop after the map has been fully explored.) Can you post the map that was generated so far? Most likely the robot_radius parameter in the Navigator is too large, so the robot cannot reach any unexplored areas in the map.

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.