ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
1 | initial version |
This is just an example how you can debug the network setup.
Do you have two computers with the following network configuration (hostname/IP)?
marvin.example.com : 192.168.1.1
hal.example.com : 192.168.1.2
If not, this is clear. You need to properly configure your computers to follow this example as it is on the page....
2 | No.2 Revision |
This is just an example how you can debug the network setup.
Directly below the line with the ssh hal
and ping marvin
, it says you should check the section Name Resolution
on this page.
Do you have two computers with the following network configuration (hostname/IP)?
marvin.example.com : 192.168.1.1
hal.example.com : 192.168.1.2
If not, this is clear. You need to properly configure your computers to follow this example as it is on the page....