The site is read-only. Please transition to use Robotics Stack Exchange
| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
 | 1 | initial version |
I have it up and running. I found some documentation that stated the connection can be done without connection to the internet, but i could not figure out how, but with the connection it worked.
What i did was to install the driver for the Phantom Omni device. After installing the driver i set up the ethernet ports on my computer. Be sure the computer is on the internet either with cable or wireless. This connection should just be the standard connection setup, Automatic (DHCP) on my pc at least. After that i connected Omni device via the ethernet cable, and went to network connections, the IPv4 settings and set the Method type to Link-Local only. Then opening the configuration executable in the driver folder i could pair the pc and the Omni.
This has been tested, and is working with this ROSnode: https://github.com/danepowell/phantom_omni
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
