Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

I finally got it to work. While defining the obstacle_layer, my min and max obstacle height parameters were set between 0.25 and 0.35. Apparently the map walls in STDR are defined to be higher or lower than that. Setting the range between 0 and 2 was enough to fix the problem and my local costmap is working fine.

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.