Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

Hi Egiljones

You are absolutely right. After added joint limited to my urdf file, the planning component visualizer worked very well. This is great! thank you very much. By the way, in my previous post, I forget to change my joint limit type from "continuous" to "revolute", which caused the program could not recognize the joint limit. best

Jayson

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.