ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange

Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

Changing the mechanical reduction of the torso is only going to mask other problems. The mechanical reduction numbers for your robot will never change, even after calibration. Recalibrating the robot only changes the offsets of each joint.

Thank you for bringing this to my attention. I'm going to investigate this value and make sure the mechanical reduction is correct for the PR2 torso.

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.10.2