ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange

Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

No, it's not possible to set different polling rates for different sets of servos connected to the same serial bus. It would increase traffic on the serial bus and decrease the maximum polling rate possible. Right now we are just asking to get the updated info on all motors in one go. You could split the leg servos and connect them separately which would also increase the maximum feedback rate as you have less motors on the line to collect info from.

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.10.2