in page "http://wiki.ros.org/ROS/NetworkSetup"
i type "ssh hal" and i get "ssh: Could not resolve hostname hal: Name or service not known"
ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
This is just an example how you can debug the network setup.
Directly below the line with the ssh hal
and ping marvin
, it says you should check the section Name Resolution
on this page.
Do you have two computers with the following network configuration (hostname/IP)?
marvin.example.com : 192.168.1.1
hal.example.com : 192.168.1.2
If not, this is clear. You need to properly configure your computers to follow this example as it is on the page....
Asked: 2016-03-19 07:56:19 -0500
Seen: 715 times
Last updated: Mar 22 '16